FPGA-based prototyping of IEEE 802.11a base band processor
نویسندگان
چکیده
منابع مشابه
FPGA-based Prototyping of IEEE 802.11a Baseband Processor
Abstract: In technical literature and especially in domestic, predominant way to examine performance of 802.11a-based systems are experiments in simulations. In this paper, we present FPGA based 802.11a prototype, which gave us a possibility to gain closer insight into the problems of OFDM system implementation. A specific design of baseband modem physical layer is discussed, along with the pre...
متن کاملFPGA prototyping of a RISC processor core for embedded applications
Application-specific processors offer an attractive option in the design of embedded systems by providing high performance for a specific application domain. In this work, we describe the use of a reconfigurable processor core based on an RISC architecture as starting point for application-specific processor design. By using a common base instruction set, development cost can be reduced and des...
متن کاملFPGA-based SIMD Processor
A massively parallel single instruction multiple data stream (SIMD) processor designed specifically for cryptographic key search applications is presented. This design aims to exploit fine grain parallelism and the high memory bandwidth available in an FPGA by integrating 95 simple processors and memory on a single FPGA chip. Performance is compared with a previously reported hardwired design o...
متن کاملFpga-Based Multi-Core Processor
The paper presents the results of investigations concerning the possibility of using programmable logic devices (FPGA) to build virtual multi-core processors dedicated specifically towards particular applications. The paper shows the designed architecture of a multi-core processor specialized to perform a particular task, and it discusses its computational efficiency depending on the number of ...
متن کاملFpga Prototyping of a Scan Based Design in an Ieee 1500 Wrapped Core
Verifying and validating complex IC designs on an FPGA prototype prior to device fabrication can provide many advantages. However, there is a lack of proper Electronic Design Automation (EDA) tool support to integrate and verify scan-based Design-for-Testability (DFT) circuitry on an FPGA. Integrating DFT technology on an FPGA prior to IC fabrication is complicated by process incompatibilities ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Serbian Journal of Electrical Engineering
سال: 2004
ISSN: 1451-4869,2217-7183
DOI: 10.2298/sjee0403125d