Formability and failure mechanisms of AA2024 under hot forming conditions
نویسندگان
چکیده
منابع مشابه
Plastometric Study of Hot Formability
P. Kawulok, I. Schindler, R. Kawulok, S. Rusz, P. Opěla, J. Kliber, M. Kawuloková VSB – Technical University of Ostrava, Faculty of Metallurgy and Materials Engineering, Czech Republic Z. Solowski, K.M. Čmiel Třinecké železárny a.s., Czech republic Formability of hypereutectoid C-Mn-Cr-V steel in hot condition was investigated with use of plastometric methods. A wide range of deformation temper...
متن کاملHot Formability of Particle reinforced Ti - Alloys
Titanium alloys exhibit mechanical and physical properties that fit structural applications demanding light-weight, corrosion resistance and biocompatibility. Ceramic reinforcements can further improve some of these mechanical properties, such as wear resistance, specific stiffness and specific strength. In comparison to continuous reinforced titanium alloys, the particle reinforced alloys (PRT...
متن کاملInvestigation on Formability of Tailor-Welded Blanks in Incremental Forming
Steel laser tailor-welded blanks (TWBs) are produced by end-to-end joining of base sheets using different welding methods. In this article, the formability of laser TWBs of St12 and St14 with thicknesses of 1 mm and 1.5 in single point incremental forming process were experimentally and numerically investigated. First, the forming limit wall angle was experimentally determined for each of the b...
متن کاملVirus silicification under simulated hot spring conditions.
Silicification of organisms in silica-depositing environments can impact both their ecology and their presence in the fossil record. Although microbes have been silicified under laboratory and environmental conditions, viruses have not. Bacteriophage T4 was successfully silicified under laboratory conditions that closely simulated those found in silica-depositing hot springs. Virus morphology w...
متن کاملFormability Limit Curves under Stretch-Bending
A common strategy for stabilizing the greenhouse gas concentrations in the atmosphere was the introduction of new emissions limits for cars, and light commercial vehicles. For that reason the automotive industry is facing new challenges in order to fulfill these considerations. One of the strategies attained, is to employ new grades of Advanced High-Strength Steel (AHSS) to replace conventional...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Engineering: A
سال: 2011
ISSN: 0921-5093
DOI: 10.1016/j.msea.2010.11.084