منابع مشابه
Development of a Wind Turbine Rotor Flow Panel Method
The ongoing trend towards larger wind turbines intensifies the demand for more physically realistic wind turbine rotor aerodynamics models that can predict the detailed transient pressure loadings on the rotor blades better than current engineering models. In this report the mathematical, numerical, and practical aspects of a new wind turbine rotor flow simulation code is described. This wind t...
متن کاملElimination of Flow-induced Instability from Steam Turbine Control Valves
This paper describes two steam turbine governor valve failures in the same installation, the troubleshooting that determined the root cause, and the new valve designed to prevent similar failures. The original governor valve design had been used successfully for many years in large multistage, multivalve steam turbines, but apparently was not reliable at the high steam pressures employed today....
متن کاملNavier-Stokes CFD Analysis of a Tidal Turbine Rotor in Steady and Planar Oscillatory Flow
Initial results of an ongoing Navier-Stokes Computational Fluid Dynamics study of horizontal axis tidal current turbine hydrodynamics are presented. Part of the underlying motivation is assessing the effects of the Reynolds number on turbine performance and loads in steady and unsteady flow regimes. The study aims at a) providing initial verification and validation of Navier-Stokes CFD for stea...
متن کامل3-D Time-Accurate CFD Simulations of Wind Turbine Rotor Flow Fields
This paper presents the results of three-dimensional and time-accurate Computational Fluid Dynamics (CFD) simulations of the flow field around the National Renewable Energy Laboratory (NREL) Phase VI horizontal axis wind turbine rotor. The 3-D, unsteady, parallel, finite volume flow solver, PUMA2, is used for the simulations. The solutions are obtained using unstructured moving grids rotating w...
متن کاملNon-linear Observer of Single-rotor Single-flow Jet Turbine Engine during Operation
The paper presents a type of observer based on reduced to minimum set of engine parameters measured directly: turbine-compressor rotational speed, engine inlet air pressure and temperature and atmospheric pressure. Results of application in analysis of data recorded during engine operation in non-stationary states of SO-3 engine (powering TS-11 Iskra aircraft) are presented. Possibilities of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Rotating Machinery
سال: 1994
ISSN: 1023-621X
DOI: 10.1155/s1023621x94000047