Flow-ability Improvement for Thin Injection Molded Products by Infrared Irradiation.
نویسندگان
چکیده
منابع مشابه
Analysis of Cavity Pressure and Warpage of Polyoxymethylene Thin Walled Injection Molded Parts: Experiments and Simulations
Process analysis and simulations on molding experiments of 3D thin shell parts have been conducted. Moldings were carried out with polyoxymethylene (POM). The moldings were performed with cavity pressure sensors in order to compare experimental process results with simulations. The warpage was characterized by measuring distances using a tactile coordinate measuring machine (CMM). Molding simul...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملInjection molded microfluidic chips featuring integrated interconnects.
An injection molding process for the fabrication of disposable plastic microfluidic chips with a cycle time of 2 min has been designed, developed, and implemented. Of the sixteen commercially available grades of cyclo-olefin copolymer (COC) that were screened for autofluorescence and transparency to ultraviolet (UV) light, Topas 8007 x 10 was identified as the most suitable for production. A ro...
متن کاملImprovement ability of EIT for Thermal monitoring during Thermal Therapy by gold nanoparticles
Introduction: To prevention the healthy tissues from irreversible damages, monitoring the temperature variation of healthy tissues is critical parameter during thermal therapies. Electrical impedance tomography (EIT) is considered as a real time imaging modality for monitoring the temperature but researches show that it suffers from low temperature resolution. In this study usi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 1999
ISSN: 1883-7417,0915-4027
DOI: 10.4325/seikeikakou.11.425