Flicker-Free LED Driver Based on Cuk Converter with Integrated Magnetics

نویسندگان

چکیده

Electric vehicles contain various types of light emitting diode (LED) devices. A significant twice-line-frequency ripple current is usually produced in a conventional offline LED driver with high power factor. In this paper, flicker-free based on isolated Cuk converter integrated magnetic technique proposed. Two inductors and transformer are combined into one core to eliminate the wave as much possible. With time domain analysis electrical circuit circuit, operation principle, operational waveforms, transfer function analyzed detail. Finally, experimental results from 30 W laboratory prototype supplied by 220 V grid validate effectiveness proposed driver.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design of Flicker-Free Electrolytic Capacitor-Less Ac-Dc Led Driver

The life of LED driver is mainly dependent on the component used in it. Elimination of electrolytic capacitor is done so that the life of LED driver will increase, if an ac-dc LED driver with power factor correction control is used than the output will be a pulsating current for driving the LED. Since the pulsating current will introduce light flicker that varies double the power line frequency...

متن کامل

Voltage-Control Based Pmbldcm By Using Cuk Converter With Pfc

This paper deals with a Cuk dc–dc converter as a single-stage power-factor-correction converter for a permanent magnet (PM) brushless dc motor (PMBLDCM) fed through a diode bridge rectifier from a singlephase ac mains. A three-phase voltage-source inverter is used as an electronic commutator to operate the PMBLDCM driving an air-conditioner compressor. The speed of the compressor is controlled ...

متن کامل

A Highly Efficient SEPIC-Flyback Integrated Converter as an LED Driver

Light-emitting diodes (LEDs) have been widely used for various lighting applications. A high power factor single-stage single-switch driver can be used to supply LEDs without using an electrolytic capacitor. By integrating the single-ended primary inductor converter (SEPIC) and flyback converter, LED driver could achieve nearly a unity power factor and low total harmonic distortion (THD). Since...

متن کامل

A Single-Stage LED Driver Based on Interleaved Buck-boost Circuit and LLC Resonant Converter

A single-stage LED driver based on interleaved buck-boost circuit and LLC resonant converter is proposed. The buck-boost circuit and LLC resonant converter are integrated by sharing switches, which can decrease the system cost and improve system efficiency. The input voltage of the buck-boost circuit is half of the rectified voltage, and two buckboost circuits are formed with the two half-bridg...

متن کامل

Overstress-Free Charge Pump White LED Driver

This paper presented a white light emitting diode (LED) driver that utilized charge pump in boosting the input voltage. The output voltage had been made sure that it was sufficient enough to overcome the forward voltage of the LED as well as provide voltage headroom for the transistors in every LED channel branch. The charge pump and its peripheral circuit, the clock booster circuit, do not suf...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: World Electric Vehicle Journal

سال: 2023

ISSN: ['2032-6653']

DOI: https://doi.org/10.3390/wevj14030075