Fixed-frequency phase-shift modulated PV-MPPT for LLC resonant converters
نویسندگان
چکیده
منابع مشابه
Time-shift Control of LLC Resonant Converters
This paper describes a new control technique for resonant converters that outperforms the direct frequency control (DFC) method implemented in all today’s commercially available control ICs. When applied to LLC resonant converters, the resulting dynamic behavior is that of a low-Q second-order system or that of a first-order system, depending on the operating conditions. Thus closing the contro...
متن کاملChapter 4 . High Frequency LLC Resonant Converter
With the development of power conversion technology, power density becomes the major challenge for front-end AC/DC converters. Although increasing switching frequency can dramatically reduce the passive component size, its effectiveness is limited by the converter efficiency and thermal management. In present industry implementations, due to the low efficiency PWM type topologies, DC/DC stage s...
متن کاملA Mppt Algorithm for Single-phase Single-stage Photovoltaic Converters
A maximum power point tracking algorithm for single-stage converters connecting photovoltaic panels to a single-phase grid is presented in this paper. The algorithm is based on the processing of current and voltage low-frequency oscillations introduced in the PV panels by the single-phase utility grid. The algorithm has been developed to allow an array of PV modules to be connected to the grid ...
متن کاملDual-Switch Quasi-Resonant Flyback Converter: Cost Effective Alternative to LLC Resonant Converters
This paper presents dual-switch Quasi-Resonant (QR) flyback topology as a cost effective and reliable alternative to the LLC resonant converter for energy efficiency regulation. The proposed topology shows excellent efficiency performance, while maintaining simple design of the conventional flyback converters. It offers higher efficiency than LLC resonant converter at medium and light load, res...
متن کاملeGaN® FETs in High Frequency Resonant Converters
Distributed power systems are prevalent in telecommunications, networking, and high-end server applications and generally utilize a 48 V bus voltage adopted from the telecom industry. From the 48 V bus, a number of isolated point of load (POL) converters power the end loads, with isolation being required for safety. The traditional distributed power architecture (DPA), shown in figure 1(a), use...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Power Electronics
سال: 2019
ISSN: 1598-2092,2093-4718
DOI: 10.1007/s43236-019-00001-w