Finite-Element Simulation of Deformation and Breakage in Sheet Metal Forming : 2nd Report, An Elastic-Plastic Analysis of Square-Cup Drawing Process
نویسندگان
چکیده
منابع مشابه
Forming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملFinite element analysis of elastic-plastic solids under Vickers indentation: surface deformation
Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...
متن کاملRigid-plastic finite-element analysis of sheet-metal forming processes using a selective membrane/shell formulation
In most sheet-metal forming processes a large part of the deforming material exhibits stretch-dominant characteristics and the bending effect is found to exist only in a limited portion of the total deforming region. Thus the use of shell or continuum elements for the whole region is not economic. A selective membrane/shell (M/S) scheme is proposed which combines the layered degenerated shell e...
متن کاملFinite-element Formulations for Problems of Large Elastic-plastic Deformation
Abstract-An Eulerian finite element formulation is presented for problems of large elastic-plastic flow. The method is based on Hill’s variational principle for incremental deformations, and is ideally suited to isotropically hardening Prandtl-Reuss materials. Further, the formulation is given in a manner which allows any conventions finite element program, for “small strain” elastic-plastic an...
متن کاملSimulation of Plastic Deformation Behavior of Ti-6Al-4V Alloy by Finite Element Method
Mechanical properties of alloys have a strong relation with microstructure and determination of their behavior can lead to multiple advantages. To obtain this goal, finite element method )FEM( is one of the best ways. In this study a series of experiments were carried out on the produced Ti-6Al-4V to obtain its mechanical characteristics and to prepare it for photographing in micro dimensions. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. A, Mechanics and material engineering
سال: 1995
ISSN: 1340-8046
DOI: 10.1299/jsmea1993.38.2_289