Feasibility Studies on Underwater Laser Surface Hardening Process
نویسندگان
چکیده
منابع مشابه
On the Optimal Control Problem of Laser Surface Hardening
We discuss an optimal control problem of laser surface hardening of steel which is governed by a dynamical system consisting of a semilinear parabolic equation and an ordinary differential equation with a non differentiable right hand side function f+. To avoid the numerical and analytic difficulties posed by f+, it is regularized using a monotone Heaviside function and the regularized problem ...
متن کاملDevelopment of a Water-Jet Assisted Underwater Laser Cutting Process
We present the development of a new underwater laser cutting process in which a water-jet has been used along with the laser beam to remove the molten material through kerf. The conventional underwater laser cutting usually utilizes a high pressure gas jet along with laser beam to create a dry condition in the cutting zone and also to eject out the molten material. This causes a lot of gas bubb...
متن کاملINFLUENCE OF LASER SURFACE HARDENING ON CORROSION PROPERTIES OF Al-Zn-Si CAST ALLOY
E. Tillová, L. Kuchariková, M. Chalupová, J. Belan, A. Vaško, I. Švecová, University of Žilina, Faculty of Mechanical Engineering, Slovak Republic This work is focused on the effect of the laser surface treatment (laser power 50 and 80 W) on microstructure and corrosion properties of self-hardened AlZn10Si8Mg cast alloy used for engine and vehicle constructions. The electrochemical impedance sp...
متن کاملOptimal control of laser hardening
We present a mathematical model for the laser surface hardening of steel. It consists of a nonlinear heat equation coupled with a system of ve ordinary diierential equations to describe the volume fractions of the occuring phases. Existence, regularity and stability results are discussed. Since the resulting hardness can be estimated by the volume fraction of martens-ite, we formulate the probl...
متن کاملExperimental Studies on the Microstructure and Hardness of Laser Transformation Hardening of Low Alloy Steel
An experimental investigation with Nd:YAG laser system was carried out to study the effects of laser hardening process parameters on the microstructure and hardness during laser hardening of EN25 steel. The laser beam is allowed to scan on the surface of the work piece by varying the laser beam power (750–1250 W) and travel speed (500–1000 mm/min) of the work table. The microstructural features...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Materials Science and Engineering
سال: 2015
ISSN: 1687-8434,1687-8442
DOI: 10.1155/2015/845273