Fatigue Properties of Pre-strained Eutectoid Steel
نویسندگان
چکیده
منابع مشابه
Characterization and Morphological Analysis of Pearlite in an Eutectoid Steel
Pearlite is a lamellar product of eutectoid decomposition, which may form in steels and non-ferrous alloys during transformations under isothermal or continuous-cooling (1,2). A pearlite nodule is composed of multiple colonies; each colony has parallel lamellae, which are orientated differently with respect to lamellae in adjacent colonies. This also exhibits a wide range of interlamellar spaci...
متن کاملInfluence of Surface Finishing on Fatigue Properties of Valve Steel
The fatigue strength of flapper valves depends among other things on surface properties of the steel. This paper deals with the effect of a tumbling method*) on bending and tensile fatigue properties of test bars. For carbon steel SANDVIK 20C an improvement was observed in several test series, particularly in the transverse direction of the strip, whereas there was little effect for stainless s...
متن کاملFatigue Properties of the Ultra-High Strength Steel TM210A
This paper presents the results of an experiment to investigate the high cycle fatigue properties of the ultra-high strength steel TM210A. A constant amplitude rotating bending fatigue experiment was performed at room temperature at stress ratio R = -1. In order to evaluate the notch effect, the fatigue experiment was carried out upon two sets of specimens, smooth and notched, respectively. In ...
متن کاملEffect of Weld Metal Microstructure on the Fatigue and Corrosion-Fatigue Properties of GTA-Welded 304 Stainless Steel
In this research, two different filler metals, ERNiCrMo-3 and ER309L, were used for developing different microstructure, austenite (γ) and austenite and ferrite (γ+δ) in the weld metal and fatigue properties of welded samples were evaluated in the air and sea water environments. Microstructural studies indicated a good agreement between predicted microstructures via schiffler diagram and metall...
متن کاملEffect of Weld Metal Microstructure on the Fatigue and Corrosion-Fatigue Properties of GTA-Welded 304 Stainless Steel
In this research, two different filler metals, ERNiCrMo-3 and ER309L, were used for developing different microstructure, austenite (γ) and austenite and ferrite (γ+δ) in the weld metal and fatigue properties of welded samples were evaluated in the air and sea water environments. Microstructural studies indicated a good agreement between predicted microstructures via schiffler diagram and metall...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2003
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.52.9appendix_210