Fatigue Behavior of Fe-Cr-Ni-based Metastable Austenitic Steels with an Identical Tensile Strength and Different Solute Carbon Contents
نویسندگان
چکیده
منابع مشابه
A Critical Assessment of First Principles Inputs for Modeling RIS in Austenitic Fe-Cr-Ni Steels
Radiation induced segregation (RIS) in austenitic Fe-Cr-Ni steels is a widely studied but incompletely understood process important for reactor components. Experimental studies have shown that Cr depletes strongly at grain boundaries, giving rise to corrosion resistance issues. Various research throughout the years has produced models that make specific assumptions about the dominant mechanisms...
متن کاملDelayed Cracking of Metastable Austenitic Stainless Steels after Deep Drawing
In metastable austenitic stainless steels, strain-induced martensitic transformation during plastic deformation enhances work hardening of the material, increasing its strength and in some cases also ductility.1,2) The presence of α’-martensite, however, may increase the susceptibility of these materials to hydrogen embrittlement phenomena, for example delayed cracking.3–6) Delayed cracking can...
متن کاملAN INVESTIGATION TO BAINITE FORMATION MORPHOLOGIES IN NI-CR BEARING LOW CARBON STEELS THROUGH THERMOMECHANICAL PROCESSING
The presence of bainite in the microstructure of steels to obtain a proper combination of strength and toughness has always been desired. The previous works however have shown that the presence of preferred bainite morphologies in the microstructure of any steel would not be readily accessible. In addition, the appearance of different bainite morphologies in the microstructure of any steel is d...
متن کاملDislocation Strengthening without Ductility Trade-off in Metastable Austenitic Steels
Strength and ductility are mutually exclusive if they are manifested as consequence of the coupling between strengthening and toughening mechanisms. One notable example is dislocation strengthening in metals, which invariably leads to reduced ductility. However, this trend is averted in metastable austenitic steels. A one-step thermal mechanical treatment (TMT), i.e. hot rolling, can effectivel...
متن کاملEFFECTS OF TENSILE STRENGTH ON FATIGUE BEHAVIOR AND NOTCH SENSITIVITY OF TI-6AL-4V
In this research, rotating bending fatigue test at minimum to maximum stress ratio of R=-1 was used for investigating the fatigue behavior of Ti-6Al-4V alloy. Both smooth and notched specimens, with elastic concentration factor, kt, of approximately 3.6 and 4.1 were used for this purpose.In addition, the effect of variation in ultimate tensile strength, UTS, on the fatigue behavior of this allo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2018
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.tetsu-2017-058