Fabrication of Circular Obelisk-Type Multilayer Microneedles Using Micro-Milling and Spray Deposition

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling

This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...

متن کامل

Fabrication of conical microneedles array using photolithography

Background and Aim: Microneedle technology has led to huge changes in the field of drug delivery medicine. Using microneedles, the drug can be injected locally, painlessly, and in very low and controlled doses with high precision. Local drug delivery through the skin with microneedles has many advantages over other methods of drug delivery. In this method, the drug does not enter the gastrointe...

متن کامل

Fabrication of ordered bulk heterojunction organic photovoltaic cells using nanopatterning and electrohydrodynamic spray deposition methods.

Organic photovoltaic cells with an ordered heterojunction (OHJ) active layer are expected to show increased performance. In the study described here, OHJ cells were fabricated using a combination of nanoimprinting and electrohydrodynamic (EHD) spray deposition methods. After an electron donor material was nanoimprinted with a PDMS stamp (valley width: 230 nm, period: 590 nm) duplicated from a S...

متن کامل

Fabrication of Biochips with Micro Fluidic Channels by Micro End-milling and Powder Blasting

For microfabrications of biochips with micro fluidic channels, a large number of microfabrication techniques based on silicon or glass-based Micro-Electro-Mechanical System (MEMS) technologies were proposed in the last decade. In recent years, for low cost and mass production, polymer-based microfabrication techniques by microinjection molding and micro hot embossing have been proposed. These t...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Frontiers in Bioengineering and Biotechnology

سال: 2018

ISSN: 2296-4185

DOI: 10.3389/fbioe.2018.00054