Extending calibration-free force measurements to optically-trapped rod-shaped samples
نویسندگان
چکیده
منابع مشابه
Extending calibration-free force measurements to optically-trapped rod-shaped samples
Optical trapping has become an optimal choice for biological research at the microscale due to its non-invasive performance and accessibility for quantitative studies, especially on the forces involved in biological processes. However, reliable force measurements depend on the calibration of the optical traps, which is different for each experiment and hence requires high control of the local v...
متن کاملFemtonewton force sensing with optically trapped nanotubes.
We extract the distribution of both center-of-mass and angular fluctuations from three-dimensional tracking of optically trapped nanotubes. We measure the optical force and torque constants from autocorrelation and cross-correlation of the tracking signals. This allows us to isolate the angular Brownian motion. We demonstrate that nanotubes enable nanometer spatial and femtonewton force resolut...
متن کاملMicroscopic flow measurements with optically trapped microprobes.
The use of optical tweezers to measure micrometer-resolution velocity fields in fluid flow is demonstrated as an extension of a scanning confocal viscosity microscope. This demonstration is achieved by detection of the motion of an optically trapped microsphere in an oscillating laser trap. The technique is validated by comparison with an independent video-based measurement and applied to obtai...
متن کاملGDQEM Analysis for Free Vibration of V-shaped Atomic Force Microscope Cantilevers
V-shaped and triangular cantilevers are widely employed in atomic force microscope (AFM) imaging techniques due to their stability. For the design of vibration control systems of AFM cantilevers which utilize patched piezo actuators, obtaining an accurate system model is indispensable prior to acquiring the information related to natural modes. A general differential quadrature element method (...
متن کاملCalibration of lateral force measurements in atomic force microscopy with a piezoresistive force sensor.
We present here a method to calibrate the lateral force in the atomic force microscope. This method makes use of an accurately calibrated force sensor composed of a tipless piezoresistive cantilever and corresponding signal amplifying and processing electronics. Two ways of force loading with different loading points were compared by scanning the top and side edges of the piezoresistive cantile...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scientific Reports
سال: 2017
ISSN: 2045-2322
DOI: 10.1038/srep42960