Experimental and Numerical Prediction of Spring back in U-bending Process
نویسندگان
چکیده
منابع مشابه
EXPERIMENTAL AND NUMERICAL INVESTIGATION ON LASER BENDING PROCESS
Laser bending is an advanced process in sheet metal forming in which a laser heat source is used to shape the metal sheet. In this paper, temperature distribution in a mild steel sheet metal is investigated numerically and experimentally. Laser heat source is applied through curved paths in square sheet metal parts. Finite element (FE) simulation is performed with the ABAQUS/CAE standard softwa...
متن کاملNumerical Simulation and Neural Network Prediction the Cold Bending Spring back for Ship Hull Plate
The accurate prediction of the spring back has great significance to the cold bending of plates. Based on the analysis of the square non pressure head CNC bending machine forming principle, the finite element model of the cold forming of the hull plate surface was established using the ANSYS/LS-DYNA finite element software. And the spring back computing research was done on the thickness of 8 m...
متن کاملNumerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Numerical Simulation of Middle Thick Plate in the U-Shaped Bending Spring Back and the Change of Thickness
In this paper, the typical U-shaped pieces were taken as the object of study and the finite element numerical simulation software Dynaform is applied to simulate the effect of sheet metal bending. The U-shaped bending spring back and its thickness change are analyzed. The influence law of main parameters of die structure to sheet thickness change and the spring back amount are obtained by combi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Faculty of Engineering. Mansoura University
سال: 2020
ISSN: 1110-0141
DOI: 10.21608/bfemu.2020.100801