Experimental and numerical modelling of wheel–rail contact and wear

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

experimental and numerical modelling of flow pattern on

abstract weirs are the most common structures for discharge measurement in engineering research. streamline curvature, non hydrostatic pressure distribution on weir and nappe adherence to the weir lead to differences between calculated and measured discharges. thus discharge coefficient, which is the ratio of real and theoretic discharges, is usually less than unity. in circular weirs the press...

Numerical modelling of the dynamic contact angle

postnatal studies of bats (pipistrellus kuhlii and miniopterus schreibersii) & histomorphology and histochemistry studies of organs and diseases of (neurergus microspilotus and n. kaiseri)

1. to determine whether difference in birth body mass influenced growth performance in pipistrellus kuhlii we studied a total of 12 captive-born neonates. bats were assigned to two body mass groups: light birth body mass (lbw: 0.89 ± 0.05, n=8) and heavy birth body mass (hbw: 1.35 ± 0.08, n=4). heavier body mass at birth was associated with rapid postnatal growth (body mass and forearm length) ...

Numerical modelling and analysis of friction contact for turbine blades

High cycle fatigue failure of turbine and compressor blades due to resonance in the operating frequency range is one of the main problems in the design of gas turbine engines. To suppress excessive vibrations in the blades and prevent high cycle fatigue, dry friction dampers are used by the engine manufacturers. However, due to the nonlinear nature of friction contact, analysis of such systems ...