Experimental and numerical analyses of homogeneity over strip width in roll compaction
نویسندگان
چکیده
منابع مشابه
Numerical Methods for Predicting Roll Press Powder Compaction Parameters
Large numbers of cohesive powders are compacted using a roll press. The principle of compaction is that particulate materials become a compact when they are subjected to high pressure. Experimental work was carried out on pharmaceutical powders [1] to determine the influence of operating parameters on the roll process compaction. Theses parameters are determined for a given powder and must be m...
متن کاملCompaction Behavior of Isomalt after Roll Compaction
The suitability of the new isomalt grade galenIQ™ 801 for dry granulation and following tableting is evaluated in this study. Isomalt alone, as well as a blend of equal parts with dibasic calcium phosphate, is roll compacted and tableted. Particle size distribution and flowability of the granules and friability and disintegration time of the tablets are determined. Tensile strength of tab...
متن کاملnumerical and experimental investigations on strip deformation in cage roll forming process for pipes with small thickness/diameter ratio
cage roll forming is one of the new methods of cold roll forming process which is widely used for producing erw pipes. in addition to less production cost and time, using cage roll forming provides smooth deformation on the strip. few studies can be found about cage roll forming because of its complexity, and the available knowledge is more experience-based and not science-based. in this paper,...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Plastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation
In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Powder Technology
سال: 2011
ISSN: 0032-5910
DOI: 10.1016/j.powtec.2010.04.030