Epoxy, ZnO, and PTFE nanocomposite: friction and wear optimization
نویسندگان
چکیده
منابع مشابه
Epoxy, ZnO, and PTFE nanocomposite: friction and wear optimization
To lower the friction coefficient and increase the wear resistance of epoxy, nanoparticles of zinc oxide and polytetrafluoroethylene (PTFE) were added in small volume percents to an epoxy matrix. Tribological testing of the samples in this study was completed on a linear reciprocating tribometer with a 250 N normal load and a 50.8 mm/s sliding speed. Several samples were made and tested followi...
متن کاملFriction and wear of PTFE - a review
Polytetrafluoroethylene (PTFE) is an important engineering material. When rubbed or slid against a hard surface, PTFE exhibits a low coefficient of friction but a high rate of wear. These unique properties of the polymer have encouraged many mechanistic and physical examinations of the processes involved in the friction and wear of this polymer. A section of such work carried out over the past ...
متن کاملWear resistant solid lubricant coating made from PTFE and epoxy
A composite coating of polytetrafluoroethylene and epoxy shows 100 · improvements in wear resistance as compared to either of its constituents alone and reduced friction coefficient under testing on a pin-on-disk tribometer. This coating is made by impregnating an expanded PTFE film with epoxy, which provides three unique functions: (1) the epoxy compartmentalizes the PTFE nodes, which is belie...
متن کاملMechanism of Friction and Wear in MoS2 and ZDDP/F-PTFE Greases under Spectrum Loading Conditions
Two different greases formulated using MoS2 and a combination of ZDDP and functionalized PTFE (F-PTFE) were examined under spectrum loading conditions where loads, frequency, and duration of the steps were treated as variables. Combination of ZDDP and F-PTFE were synergistic resulting in a significant reduction in the wear and friction under spectrum loading condition. Decreasing the time step ...
متن کاملA low friction and ultra low wear rate PEEK/PTFE composite
This paper presents a PEEK filled PTFE composite that exhibits low friction and ultra-low wear. It is hypothesized that a synergistic effect shuts down the dominant wear mechanism of each constituent. The friction coefficient and wear rate of this composite material on lapped stainless steel were evaluated for samples with PEEK wt.% of 0, 5, 10, 20, 30, 40, 50, 70 and 100 using a linear recipro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tribology Letters
سال: 2006
ISSN: 1023-8883,1573-2711
DOI: 10.1007/s11249-006-9089-5