Electrolytic White Coloring of Titanium in H3PO4-H2SO4-Al2(SO4)3-ZnSO4System Electrolytic Bath
نویسندگان
چکیده
منابع مشابه
Seebeck Envelope Calorimetry with a Pd|d2o+h2so4 Electrolytic Cell
Anomalous excess heat in Pd|D2O+H2SO4 electrolytic cells was confirmed using an accurate method of heat measurement, Seebeck Envelope Calorimetry. A cell was placed in the calorimeter, which measures the output heat flux directly and avoids many of the problems other methods have. The maximum excess power thus far was 1.3 W (or 11 W cm3) with input power of 13 W at a current density of 0.4 A c...
متن کاملElectrolytic Chlorogen
appeared a report on Electrolytic Chlorogen by Captain W. Hodgkinson, r.e., and Mr. C. M. Hutchinson, c.i.ii., Imperial Agricultural Bacteriologist of the Agricultural Research Institute, Pusa. The principal objects of this enquiry, which were carried out under the auspices of the Army Department (Simla), were to determine the possibility of preparing in India from indigenous materials and by s...
متن کاملElectrolytic Chlorogen
Sik.?I have received the enclosed letter from Mr. Hutchinson of Pusa in regard to the remarks on Electrolytic Chlorogen contained in the report of my paper on "The Selection of a Disinfectant" in the May issue of the Gazette. Whilst I am not entirely in agreement with Mr. Hutchinson in his estimation of costs based only 011 a phenol coefficient,? (Lysol, for instance, is extensively used by gyn...
متن کاملEXCESS HEAT REPRODUCIBILITY AND EVIDENCE OF ANOMALOUS ELEMENTS AFTER ELECTROLYSIS IN Pd|D2O+H2SO4 ELECTROLYTIC CELLS
Electrolyte temperature is a key factor in excess heat production using Pd|D2O+H2SO4 electrolytic cells. Best results are obtained when the electrolyte temperature is close to the boiling point. Stable excess heat is generated by events on or near the Pd cathode surface. In addition to the stable excess heat, heat bursts are sometimes observed. These occurred most frequently in experiments usin...
متن کاملPREPARATION OF CATALYTIC COATING OF TITANIUM OXIDE BY MEANS OF ELECTROLYTIC DEPOSITION
In the current research, the optimum conditions for the electrolytic deposition of TiO2 coatings on titanium pieces were experimentally investigated. Flat pieces of commercially available titanium with dimensions of 50 x20 x3 mm were used as the anode and cathode electrodes. The coatings were applied on the cathode in an electrolyte solution essentially from water and methanol, containing diffe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Colour Material
سال: 1992
ISSN: 0010-180X
DOI: 10.4011/shikizai1937.65.16