Electrodeposition of Copper on AZ91 Mg Alloy in Cyanide Solution
نویسندگان
چکیده
منابع مشابه
Initiation of fatigue cracks in AZ91 Mg alloy processed by ECAP
Mechanism of fatigue crack initiation was investigated in ultrafine-grained (UFG) magnesium alloy AZ91 processed by equal channel angular pressing (ECAP). Fatigue behaviour of UFG material was compared to the behaviour of material in an initial as-cast state. Focused ion beam technique (FIB) was applied to reveal the surface relief and early fatigue cracks. Two substantially different mechanism...
متن کاملCopper Electrodeposition on a Magnesium Alloy (AZ80) with a U-Shaped Surface
Cu electrodeposition was performed on a cylindrical AZ80 substrate with a U-shaped surface. A uniform deposition of Cu was achieved on an AZ80 electrode via galvanostatic etching, followed by Cu electrodeposition in an eco-friendly alkaline Cu plating bath. Improper wetting and lower rotational speeds of the AZ80 electrode resulted in an uneven Cu deposition at the inner upper site of the U-sha...
متن کاملPulsed Electrodeposition of Copper
Pulsed electrolysis of copper has been systematically investigated by electrodepositing copper from a copper sulfate bath. Pulse duty cycles of 5 to 80 percent, at frequencies from 10 to 100 Hz with current densities ranging from 2.5 to 7.5 A/dm2 were employed. The appearance of Hull Cell panels with both direct current and pulsed current was recorded. The influence of pulsed current on current...
متن کاملOxide Film and Porosity Defects in Magnesium Alloy Az91
Porosity is a major concern in the production of light metal parts. This work aims to identify some of the mechanisms of microporosity formation in magnesium alloy AZ91. Microstructure analysis was performed on several samples obtained from gravity-poured ingots in graphite plate molds. Temperature data during cooling was acquired with type K thermocouples at 60 Hz at three locations of each ca...
متن کاملELECTRODEPOSITION OF NANO SIZE HYDROXYAPATITE COATING ON TI ALLOY
A film of osteoconductive and biocompatible material on biomedical metallic implants can create bioactivity of the implant and shorten healing time. Hydroxyapatite, that is the most important mineral part of human bone, was coated on Ti6Al4V using cathodic electrode position process. Pulse electrode position technique was used and the effects of different parameters such as potential, duty cycl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean institute of surface engineering
سال: 2016
ISSN: 1225-8024
DOI: 10.5695/jkise.2016.49.3.238