Electrical Characteristics of Na-Doped Alumina Humidity Sensor
نویسندگان
چکیده
منابع مشابه
Electrical Properties of Indium Doped Alumina (Al2O3) Thin Films
To know the electrical properties of any materials is very important for practical application of that material. In this paper I have tried to find out the proper electrical properties of Indium doped Alumina (Al2O3) for practical application of this Alumina. For this purpose all thin films are deposited on glass substrate by electron beam evaporation technique at a pressure of about 1.5 x 10-6...
متن کاملDoped spiral alumina nanowires.
Spiral alumina nanowires, doped with Cr and Si, are directly and reliably produced in bulk quantities via annealing of high entropy alloys.
متن کاملNanomechanical humidity detection through porous alumina cantilevers
We present here the behavior of the resonance frequency of porous anodic alumina cantilever arrays during water vapor adsorption and emphasize their possible use in the micromechanical sensing of humidity levels at least in the range of 10-22%. The sensitivity of porous anodic aluminium oxide cantilevers (Δf/Δm) and the humidity sensitivity equal about 56 Hz/pg and about 100 Hz/%, respectively....
متن کاملEffect of ion concentration on viscosity, electrical conductivity and deposit weight of doped nano alumina prepared by electrophoretic deposition
Viscosity, electrical conductivity and deposit weight were determined for Electrophoretic deposition (EPD) Mg2+-, Y3+-, La3+- and Ce4+-doped alumina's ethanolic suspensions prepared at dopant concentration between 350 to 1350 ppm. The concentration of XCly (X, y were: Mg, 2; Y, 3; Ce, 3 and La, 3, respectively) the charging salt, is also found to be a critical factor to control the viscosity. I...
متن کاملImpedance characteristics of thin films humidity sensing elements based on Bi - doped TiO 2
The paper proposes results from the investigations of humidity sensing elements based on Bi-doped TiO 2 thin films, prepared by a sol-gel method. Titanium n-butoxide was used as a starting material for the preparation of the experimental samples, and bismuth acetate as doping compound. The samples were sintered at 400°C. Afterwards, the samples were placed into a calibrated humidity chamber and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 1989
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.97.1281