Effects of Tool Flank Wear on Occurrences of Regenerative Chatter. 1st Report. A Model of Dynamic Undercutting Forces Caused by Tool Flank Wear.
نویسندگان
چکیده
منابع مشابه
Evaluation of Flank Wear of Iron-rich Binder Carbide Cutting Tool in Turning of Titanium Alloy
Despite the fact that Titanium material has been considered as difficult to cut material, its usage has been increasing day by day in all engineering sectors; wherever criticality is encountered. Many studies are going on in view of increasing tool life at high cutting speed to improve productivity. In this study, attempt has been made to see the effect of iron as a partial substitution along ...
متن کاملCharacterizations of cutting tool flank wear-land contact
Metal deposition at the tool flank wear-land during machining is a common phenomenon, especially in machining aluminum alloys and annealed teels. The cause of metal deposit has not been studied and the characteristics of the wear-land and deposit contact are not completely known. In his study, a turning test was conducted using tungsten carbide (WC) tools with pre-generated wear-land to machine...
متن کاملInvestigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملCutting Forces in Hard Turning Comprising Tool Flank Wear and Its Implication for the Friction between Tool and Workpiece
Original scientific paper In this paper, the orthogonal cutting force model is proposed comprising forces due to flank wear in addition to the forces for chip formation during the hard turning of round bar made of steel 60WCrV7 hardened at 55+2HRc. Cutting force model includes two tool conditions: perfectly sharp tool with VBB = 0 and tool with maximum permissible flank wear VBBmax. Based on cu...
متن کاملFractal Estimation of Flank Wear in Turning
A novel fractal estimation methodology, that uses—for the first time in metal cutting literature—fractal properties of machining dynamics for online estimation of cutting tool flank wear, is presented. The fractal dimensions of the attractor of machining dynamics are extracted from a collection of sensor signals using a suite of signal processing methods comprising wavelet representation and si...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1995
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.61.1279