Effect of stress ratio on fatigue-crack growth in 7075-T6 aluminum-alloy sheet
نویسندگان
چکیده
منابع مشابه
Ionic Inhibition of Environmental Fatigue Crack Growth in 7075-t6
The objective of this study is to quantify and understand the effectiveness of a hexavalent chrome replacement ion to inhibit environmentally assisted fatigue crack propagation (EFCP) in high strength aluminum alloys. Because of dynamic-cyclic stress (or strain) loading, fatigue degradation occurs at stress levels considerably lower than the tensile or yield strength; degradation is exacerbated...
متن کاملAccelerated Threshold Fatigue Crack Growth Effect – Powder Metallurgy Aluminum Alloy
Fatigue crack growth (FCG) research conducted in the near threshold regime has identified a room temperature creep crack growth damage mechanism for a fine grain powder metallurgy (PM) aluminum alloy (8009). At very low ∆K, an abrupt acceleration in room temperature FCG rate occurs at high stress ratio (R = Kmin/Kmax). The near threshold accelerated FCG rates are exacerbated by increased levels...
متن کاملStress Ratio Effects on Crack Opening Loads and Crack Growth Rates in Aluminum Alloy 2024
Since its founding, NASA has been dedicated to the advancement of aeronautics and space science. The NASA Scientific and Technical Information (STI) Program Office plays a key part in helping NASA maintain this important role. The NASA STI Program Office is operated by Langley Research Center, the lead center for NASA's scientific and technical information. The NASA STI Program Office provides ...
متن کاملSurface Characterizations of Fretting Fatigue Damage in Aluminum Alloy 7075-T6 Clamped Joints: The Beneficial Role of Ni–P Coatings
This paper aims to characterize the surface damage as a consequence of fretting fatigue in aluminum alloy 7075-T6 plates in double-lap bolted joints through XRD, surface profilometry, and SEM analyses. The main focus was on the surface roughness and chemical phase composition of the damaged zone along with the identification of fretting fatigue crack initiations over the surface of the material...
متن کاملEffect of Stress Ratio on Fatigue Crack Growth Behavior of Magnesium Alloy AZ61 under 3.5 Mass% NaCl Spray Environment*
Fatigue crack growth behavior of AZ61 magnesium alloy was investigated in low humidity (55% relative humidity) and 3.5% NaCl spray environments under various stress ratios. Fatigue crack growth rates became higher with increasing load ratio for both environments. However, the results of fatigue crack growth test under 3.5% NaCl spray environment showed lower fatigue crack propagation rate compa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Fracture Mechanics
سال: 1969
ISSN: 0013-7944
DOI: 10.1016/0013-7944(69)90003-4