Early Stages of Plastic Deformation in Low and High SFE Pure Metals
نویسندگان
چکیده
منابع مشابه
Severe Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملStrengthening of Metals through Severe Plastic Deformation
The processing of bulk metals through the application of severe plastic deformation (SPD) provides an opportunity for achieving excellent grain refinement to the submicrometer or even the nanometer range. These SPD procedures produce materials exhibiting improved mechanical properties including very high strength. This report describes recent results demonstrating the strengthening of conventio...
متن کاملplastic instability in equibiaxial deformation of sheet metals
plastic instability which results in the localization and failure of sheet metals has been studied in equibiaxial stretching of commercial purity aluminium sheet. attention was focussed on two main industrial conditions of the material. these were representative of the materials that could be processed by the commercial batchannealing process (slow heating, long time) or by a continuous anneali...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملPlastic anisotropy and associated deformation mechanisms in nanotwinned metals
Anisotropic plastic deformation in columnar-grained copper in which preferentially oriented nanoscale twins are embedded is studied by experimental testing, crystal plasticity modeling and molecular dynamics simulations. The dominant deformation mechanism can be effectively switched among three dislocation modes, namely dislocation glide in between the twins, dislocation transfer across twin bo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2020
ISSN: 2075-4701
DOI: 10.3390/met10060751