Dynamic Modeling of Lift Hoisting Mechanism Block Pulley
نویسندگان
چکیده
منابع مشابه
Modeling Dynamic Lift Response to Actuation
The dynamic lift response of an airfoil to sinusoidal amplitude variations from a synthetic jet actuator was studied. The wing was at a fixed angle of attack, and the actuator operated in a ‘burst-mode’ with a fixed duty cycle. The actuator burst amplitude was used as a control signal, which was varied between an ‘off’ condition and the actuator saturation voltage. Three dimensionless frequenci...
متن کاملSystem modeling with dynamic reliability block diagrams
System features like security, availability and reliability, usually summarized under the concept of dependability, recently are receiving increasing attention due to the high complexity of modern systems. This imposes that specific requirements and explicit or tighter constraints have to be satisfied. However, with particular reference to reliability, there is a lack of suitable tools to prope...
متن کاملdynamic coloring of graph
در این پایان نامه رنگ آمیزی دینامیکی یک گراف را بیان و مطالعه می کنیم. یک –kرنگ آمیزی سره ی رأسی گراف g را رنگ آمیزی دینامیکی می نامند اگر در همسایه های هر رأس v?v(g) با درجه ی حداقل 2، حداقل 2 رنگ متفاوت ظاهر شوند. کوچکترین عدد صحیح k، به طوری که g دارای –kرنگ آمیزی دینامیکی باشد را عدد رنگی دینامیکی g می نامند و آنرا با نماد ?_2 (g) نمایش می دهند. مونت گمری حدس زده است که تمام گراف های منتظم ...
15 صفحه اولEfficient Modeling of Extensible Cables and Pulley Systems in ADAMS
A new method has been developed for accurately and efficiently modeling string-like cable components that change length during an event. String-like components are flexible elements that only support tension loads, not compression nor bending. The method is also applicable to many and various kinds of ropes, tapes, chains and belts. It includes the effects of both variable mass and variable sti...
متن کاملDynamic Measurement of Valve Lift Force
The paper describes tests carried out on disc valves in which the valve seat was withdrawn from the valve wh).le a pressure difference existed across the valve. Simultaneous measurements were made of the force on the valve, the pressure in the plenum chamber and the displacement of the seat from the valve. Force measurements are compared with values of force measured during continuous flow cond...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2016
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2016.07.300