منابع مشابه
On the fracture toughness anisotropy of mechanically poled ferroelectric ceramics
In this paper an incremental constitutive theory for the deformation due to switching in ferroelectrics is applied to predict the fracture toughness anisotropy in these materials after mechanical poling. Mechanical poling of an initially unpoled specimen differs from electrical poling in that only mechanical stresses are applied to the material. Therefore, no electrical polarization can develop...
متن کاملThermal-stress resistance and fracture toughness of two tool ceramics
The thermal-stress resistance and fracture strength behaviour of two oxide ceramics (a hot-pressed pure AI203 and a composite ceramic NTK-HC2) subjected to severe thermal shocks have been investigated. The damage resistance parameter (Kic/of)2 for both ceramics is also determined for a wide range of temperatures (25 ~ to 800 ~ C) and cross-head rates (10 -2 cm min -1 ~ 2.5 m sec -1 ). Fracture ...
متن کاملSimplified method for determining fracture toughness of two dental ceramics.
This study compared the fracture toughness values (KIC), which were derived from simplified techniques: the indentation fracture (IF), the indentation strength (IS), and fractographic approach to that from a standard testing using surface cracks in flexure (SCF). Forty bar specimens, twenty IPS Empress(®) Esthetic and twenty IPS e.max(®)Ceram were prepared. Ten specimens in each material were t...
متن کاملFracture toughness and thermal shock of tool and turbine ceramics
The behaviour of some commercial tool carbides and turbine ceramics has been investigated in regard to resistance to crack initiation, crack propagation and retained strength after thermal shock. New data are provided, particularly measurements of the fracture toughness of these materials at actual operating temperatures (up to 1200 ~ C). Many of the materials did not follow the generally accep...
متن کاملFracture Toughness of Advanced Ceramics at Room Temperature
This report presents the results obtained by the five U.S. participating laboratories in the Versailles Advanced Materials and Standards (VAMAS) round-robin for fracture toughness of advanced ceramics. Three test methods were used: indentation fracture, indentation strength, and single-edge pre-cracked beam. Two materials were tested: a gas-pressure sintered silicon nitride and a zirconia tough...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 1989
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.97.1392