Dynamic Characteristic and Power Consumption on an Electro-Pneumatic Hybrid Positioning System
نویسندگان
چکیده
منابع مشابه
Torque Reduction Control for an Electro- Pneumatic Hybrid Vertical Positioning System
This paper deals with torque reduction control for an electro-pneumatic hybrid vertical positioning system composed of a servomotor a pneumatic and a mechanical driving sub-system. The servomotor, coupled with a ball screw connected to the load by nut, enables to position a load vertically. The servomotor with small capacity, as well as energy saving, is required for cost down. To realize its s...
متن کاملFuzzy logic positioning system of electro-pneumatic servo-drive
Development of automation and robotization in manufacturing process stimulates interest in pneumatic servo-systems whose advantages include low manufacturing costs, high dynamics and reliability (Situm et al., 2004). Unsatisfactory positioning accuracy of multiaxis pneumatic servosytems considerably reduces their application in manipulating machines, manipulators and robots. Rapid advance in pa...
متن کاملImproved Tracking and Switching Performance of an Electro-Pneumatic Positioning System
For robotic systems that use on/off (solenoid) pneumatic actuators, a sliding mode control law for precise position control and low switching (open-close) activity of the valves is presented in this paper. Given a pneumatic actuator with two chambers and four solenoid valves, there are sixteen possible input combinations defined directly from the state of the four on/off valves present in the s...
متن کاملAn Unified Approach to Limits on Power Generation and Power Consumption in Thermo-Electro-Chemical Systems
This research presents a unified approach to power limits in power producing and power consuming systems, in particular those using renewable resources. As a benchmark system which generates or consumes power, a well-known standardized arrangement is considered, in which two different reservoirs are separated by an engine or a heat pump. Either of these units is located between a resource fluid...
متن کاملPneumatic Positioning System for Precision Assembly
Micro assembly is typically characterised by positioning tolerances below a few micrometers. In the case of a hybrid micro system assembly, such as optical glass fibres, micro ball lenses or micro probes for measurement tasks, even positioning accuracies in the sub-micrometer range have to be achieved. Due to the need for highly accurate assembly systems and extensive alignment procedures the a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the JFPS International Symposium on Fluid Power
سال: 2005
ISSN: 2185-6303
DOI: 10.5739/isfp.2005.363