Dual Drive Curve Tool Path Planning Method for 5-axis NC Machining of Sculptured Surfaces
نویسندگان
چکیده
منابع مشابه
Non-Isoparametric Three Axis NC tool path generation for finish machining of sculptured surfaces
Sculptured surfaces are usually machined to their final shapes by a series of rough and finish passes. After each pass, excess material may be left at some concave or C1 discontinuous areas. Traditionally these undercut areas are “cleaned up” by repeatedly machining the whole surface with progressively smaller cutting tools. We present an algorithm for automatically identifying areas with exces...
متن کاملAccurate Modeling Method for Generalized Tool Swept Volume in 5-axis NC Machining Simulation
Presented in this article is a new accurate tool swept volume generation algorithm based on a generalized cutter for five-axis NC simulation and verification. Based on the surface envelope theory and the differential geometry, using analytical method, the strict deduction process of critical curve equation and swept envelope equation for generalized cutter are given. The motion feature of the c...
متن کاملTool Path Planning for Machining Free-form Surfaces
This paper is about new iso-parametric tool path planning for machining trimmed freeform surfaces. The trimmed surface has been re-parameterized by two different parameterization techniques, namely, the partial differential equation method and the newly developed boundary interpolation method. The efficiency of the scheme has been measured in terms of path length and computational time needed f...
متن کاملManufacturability Analysis for 5-Axis Sculptured Surface Machining
The general algorithm for manufacturability analysis of 5-axis sculptured surface machining is presented in this analytic contours of a sculptured surface, the method has been considered as au efficient way only for a small product related feature set [5] so far. A framework for a new, kinematics-based method is presented in [6] . It provides a basis for concurrent geometric shape design and ma...
متن کامل5-Axis Flank Milling of Sculptured Surfaces
This chapter covers the various free-form surface flank milling strategies available, focusing in particular on those for ruled surfaces as widely used in defining turbomachine parts. All these positionings seek to reduce interference between the cutting tool and the surface to be milled so as to respect the tolerances dictated by the Design Office. The range of strategies presented goes from t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Journal of Aeronautics
سال: 2010
ISSN: 1000-9361
DOI: 10.1016/s1000-9361(09)60245-4