Discussion: “Internal Bearing Chamber Wall Heat Transfer as a Function of Operating Conditions and Chamber Geometry” [ASME J. Eng. Gas Turbines Power, 122, No. 2, pp. 314–320]1
نویسندگان
چکیده
منابع مشابه
Computational Study of Radiative and Convective Heat Transfer in a Cylindrical Combustion Chamber
In this paper, the effect of cold air on the fluid flow inside the cylindrical combustion chamber and its wall temperature distribution have been studied computationally, taking into account the effect of radiative heat transfer from hot gases. The results have been compared with the case that radiative heat transfer was neglected. It is observed that the reattachment length increases when incr...
متن کاملOperating Range Expansion in a HCCI Natural Gas Engine Using Charge and Thermal Stratification in Combustion Chamber
HCCI operating window has two distinct boundaries of knock at higher load region and misfiring/partial burning at lower load region. Moreover, there is no conventional direct way of controlling combustion timing in an HCCI engine. In this research, experimental study were carried out to investigate the effect of thermal and charge stratification on expansion of the operating range of a natural ...
متن کاملModeling of Heat Losses Within Combustion Chamber of Diesel Engines
The cylinder working fluid mean temperature, rate of heat fluxes to combustion chamber and temperature distribution on combustion chamber surface will be calculated in this research. By simulating thermodynamic cycle of engine, temperature distribution of combustion chamber will be calculated by the Crank-Nicolson method. An implicit finite difference method was used in this code. Special treat...
متن کاملClosure to “Discussion of ‘Factors of Safety for Richardson Extrapolation’ ” (2011, ASME J. Fluids Eng., 133, p. 115501)
The Technical Brief by Roache [1] presents ten items of discussion of our factor of safety (FS) method for solution verification [2]. Our responses are listed below item-by-item using the same numbering as Roache. The nomenclature mostly follows our own and not Roache’s such as pRE for the order of accuracy calculated using the Richardson Extrapolation as opposed to the observed order of conver...
متن کاملTemperature profile of a power-law fluid over a moving wall with arbitrary injection/suction and internal heat generation/absorption
The heat transfer for a non-Newtonian power-law fluid over a moving surface is investigated by applying a uniform suction/injection velocity profile. The flow is influenced by internal heat generation/absorption. The energy equation is solved at constant surface temperature condition. The Merk-Chao series is applied to obtain a set of ODEs instead of a complicated PDE. The converted ordinary diffe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering for Gas Turbines and Power
سال: 2000
ISSN: 0742-4795,1528-8919
DOI: 10.1115/1.483218