Discussion: Determination of the coefficient of consolidation using a least squares method
نویسندگان
چکیده
منابع مشابه
Determination of the coefficient of consolidation using a least squares method
I. G. Doran and J. D. McKinley, Queen’s University Belfast The paper proposes the use of an approximation, suggested by Hansen, to the exact analytical solution of the Terzaghi consolidation equation, as the basis for the determination of the coefficient of consolidation from the results of a consolidation test using a least squares error adjustment procedure. This is an area of considerable pr...
متن کاملLeast – Squares Method For Estimating Diffusion Coefficient
Abstract: Determination of the diffusion coefficient on the base of solution of a linear inverse problem of the parameter estimation using the Least-square method is presented in this research. For this propose a set of temperature measurements at a single sensor location inside the heat conducting body was considered. The corresponding direct problem was then solved by the application of the ...
متن کاملLEAST – SQUARES METHOD FOR ESTIMATING DIFFUSION COEFFICIENT
Determining the diffusion coefficient based on the solution of the linear inverse problem of the parameter estimation by using the Least-square method is presented. A set of temperature measurements at a single sensor location inside the heat conducting body is required. The corresponding direct problem will be solved by an application of the heat fundamental solution.
متن کاملbuckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Partial least squares- least squares- support vector machine modeling of ATR-IR as a spectrophotometric method for detection and determination of iron in pharmaceutical formulations
Iron is an essential element used as supplement in different dosage-forms. Different time and expenditure-consuming methods introduced for detection and determination of elemental ions such as atomic absorption. In this research, two different and routine methods containing ATR-IR and atomic absorption were applied to define the amount of iron in 198 samples containing different concentrations ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Géotechnique
سال: 2006
ISSN: 0016-8505,1751-7656
DOI: 10.1680/geot.2006.56.1.73