Differing microstructural properties of 7075-T6 sheet and 7075-T651 extruded aluminium alloy
نویسندگان
چکیده
منابع مشابه
Ionic Inhibition of Environmental Fatigue Crack Growth in 7075-t6
The objective of this study is to quantify and understand the effectiveness of a hexavalent chrome replacement ion to inhibit environmentally assisted fatigue crack propagation (EFCP) in high strength aluminum alloys. Because of dynamic-cyclic stress (or strain) loading, fatigue degradation occurs at stress levels considerably lower than the tensile or yield strength; degradation is exacerbated...
متن کاملExtrusion of 7075 aluminium alloy through double-pocket dies to manufacture a complex profile
Low-temperature incipient melting and high deformation resistance of aluminium alloy AA7075 place extraordinary demands on extrusion die design and process optimization, especially when the shape of the extrudate is complex. The present case study was aimed at combining the considerations on die design and process optimization for the alloy to manufacture a complex solid profile with large diff...
متن کاملApplication of the GTN Model in Ductile Fracture Prediction of 7075-T651 Aluminum Alloy
In this paper the capability of Gurson-Tvergaard-Needleman (GTN) model in the prediction of ductile damage in 7075-T651 aluminum alloy is investigated. For this purpose, three types of specimens were tested: Standard tensile bars, Round notched bar (RNB) specimens and compact tension (C(T)) specimens. Standard tensile bar tests were used to obtain the mechanical properties of the material and t...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملINVESTIGATION OF MICROSTRUCTURAL AND MECHANICAL PROPERTIES OF 7075 AL ALLOYPREPARED BY SIMA METHOD
The microstructure and mechanical properties of 7075 wrought aluminum alloy produced by strain induced melt activation (SIMA) route were investigated.Also liquid volume fraction measurement was studied by three procedures. Remelting process was carried out in the range of 560 to 610 °C for 20 min holding. The microstructure in the semi-solid state consists of fine spherical solid grains surroun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2011
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2011.04.516