Differential Thermal Analysis
نویسندگان
چکیده
منابع مشابه
Scaling analysis of negative differential thermal resistance.
Negative differential thermal resistance (NDTR) can be generated for any one-dimensional heat flow with a temperature-dependent thermal conductivity. In a system-independent scaling analysis, the general condition for the occurrence of NDTR is found to be an inequality with three scaling exponents: n(1)n(2) < -(1+n(3)), where n(1) ∈ (-∞,+∞) describes a particular way of varying the temperature ...
متن کاملCharacterization and analysis of waxes by differential thermal analysis.
The characterization of waxes by differential thermal analysis is described. An endothermic peak at 475-480 degrees is characteristic of microcrystalline and polyethylene waxes, and measurement of its area provides a method for the estimation of these waxes in mixtures.
متن کاملDifferential Thermal Analysis and Dielectric Studies on Neopentanol under Pressure
Differential thermal analysis (DTA) and dielectric measurements have been performed on 2,2-dimethyl-l-propanol (neopentanol) up to 200 MPa. Neopentanol exhibits at least one orientationally disordered (ODIC) phase (solid I) that transforms at lower temperatures to a non-plastic phase (solid II). There is evidence of a further O D I C phase denoted as solid I'. The pressure dependence of the pha...
متن کاملDifferential thermal analysis of commercial and dental waxes.
Since phase changes generally result in dimensional changes, the temperatures at which the phase changes occur in waxes and the influence of adding one wax to another are important in understanding the behavior of waxes. Differential thermal analysis (DTA) offers a useful tool in the study of phase transitions. This study examines the temperature of phase transitions for various commercial, den...
متن کاملDifferential thermal analysis and solution growth of intermetallic compounds
To obtain single crystals by solution growth, an exposed primary solidification surface in the appropriate, but often unknown, equilibrium alloy phase diagram is required. Furthermore, an appropriate crucible material is needed, necessary to hold the molten alloy during growth, without being attacked by it. Recently, we have used the comparison of realistic simulations with experimental differe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Mineralogical Society of Japan
سال: 1963
ISSN: 1883-7018,0454-1146
DOI: 10.2465/gkk1952.6.17