Development of sharpness tester for grinding wheel face.
نویسندگان
چکیده
منابع مشابه
design, development and evaluation of a single wheel tester
the single wheel tester is an experimental device used to measure wheel forces when studying the relation of soil and wheel in a soil bin or in the field. in the model under development, a special frame holding the test wheel is connected to a loading carriage by two pairs of vertical rails and four rollers to provide a floating connection. by applying a driving torque to the test wheel shaft, ...
متن کاملMonitoring of wheel dressing operations for precision grinding
In grinding operation, on-line process monitoring of dressing will ensure the quality of the grinding wheel and will achieve reproducible surface finish. The results of a study conducted to evaluate the feasibility and effectiveness of Acoustic Emission (AE) sensors in online monitoring of dressing is reported. Two aspects of the process are addressed. The first is the detection of undesired wh...
متن کاملVitreous bond silicon carbide wheel for grinding of silicon nitride
This study investigates the grinding of sintered silicon nitride using a SiC wheel with a fine abrasive grit size and dense vitreous bond. The difference of hardness between the green SiC abrasive and sintered Si3N4 workpiece (25.5 vs. 13.7 GPa) is small. Large grinding forces, particularly the specific tangential grinding forces, are observed in SiC grinding of Si3N4. The measured specific gri...
متن کاملDesign of Robust Grinding Wheel Reciprocating Arrangement for Precision Point-grinding Machining
This research is to investigate the dynamic characteristics of the grinding process. A kind of robust grinding wheel reciprocating arrangement is schemed out, which realizes the precise point-grinding machining. The grinding wheel reciprocating movement is driven by a linear motor to replace the traditional crank or hydraulic pressure drive device. Based on the time series method, the modal exp...
متن کاملAdaptive Finite Element Discretisation of the Spindle Grinding Wheel System
In the simulation of the NC-shape grinding process, a finite element model of the grinding machine is included. To enhance the accuracy and efficiency of the finite element computation, a posteriori error estimation and resulting adaptive mesh refinement techniques are used. In this note, a dual weighted a posteriori error estimate for a linear second order hyperbolic model problem is derived. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1988
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.54.2176