Design of 4.48–5.89 GHz LC-VCO in 65 nm RF CMOS Technology
نویسندگان
چکیده
منابع مشابه
LC-active VCO for CMOS RF transceivers
A novel fully integrated CMOS LC tank VCO is presented. The LC tanks are implemented by exploiting the active circuit ‘boot-strapped inductor’ (BSI), which behaves like a high-quality factor inductor. Particularly, the LC tanks have been implemented by introducing a new version of the CMOS BSI circuit, which provides better versatility and design reliability. In order to verify the effectivenes...
متن کاملA 56-GHz LC-Tank VCO With 17% Tuning Range in 65-nm Bulk CMOS for Wireless HDMI
A voltage-controlled oscillator (VCO) with a central frequency of 56 GHz and a 17% tuning range is presented. The oscillation frequency is tuned both by an analog input and by a 3-bit digital control bus using the same type of differential varactors. It achieves a record figure of merit, considering tuning range of 186.8 dBc/Hz and is able to address the full wireless high-definition multimedia...
متن کاملA 5 GHz LC-VCO with Active Common Mode Feedback Circuit in Sub-micrometer CMOS Technology
A 1.2V 5GHz low-cost voltage-controlled oscillator (VCO) with active common mode feedback has been implemented in a CMOS/RF 90nm technology for a robust I/Q generation using a frequency divider-by-2 (DIV2). As the input common mode of the DIV2 affects critically its performance, a calibration method to correct the output common mode of the VCO has been proposed and validated through post-layout...
متن کاملA 74%, 1.56–2.71 GHz, WIDE-TUNABLE LC-TUNED VCO IN 0.35- m CMOS TECHNOLOGY
A wide-tuning monolithic LC-tuned VCO is presented. The proposed VCO accomplishes wide tuning by utilizing binary weighted switched varactor combinations operating at minimum or maximum value, in addition to a linearly varying interpolation varactor. Measurements show 74% of tuning at a range of 1.56–2.71 GHz, with the phase noise ranging from 136 dBc/Hz to 108 dBc/Hz at 1 MHz offset. The VCO i...
متن کاملDesign and implementation of configurable ESD protection cell for 60-GHz RF circuits in a 65-nm CMOS process
The configurable electrostatic discharge (ESD) protection cells have been implemented in a commercial 65-nm CMOS process for 60-GHz RF applications. The distributed ESD protection scheme was modified to be used in this work. With the consideration of parasitic capacitance from I/O pad, the ESD protection cells have reached the 50-X input/output matching to reduce the design complexity for RF ci...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics and Electrical Engineering
سال: 2014
ISSN: 2029-5731,1392-1215
DOI: 10.5755/j01.eee.20.2.6383