Design Considerations for IC Color Television Receiver
نویسندگان
چکیده
منابع مشابه
FPGA based GPS receiver design considerations
A project to build a GPS receiver using an FPGA for base-band processing began in 2004. The new receiver platform uses a commonly available RF front end ASIC to convert the GPS signals to a suitable IF. The digital design for baseband processing is normally a reasonably straight forward task. However, because the received GPS signals are at such low levels this presents some challenges. One of ...
متن کاملDesign Considerations for a GBT 68-92 GHz Receiver
Scientific motivation for equipping the GBT with receivers for the 3mm band (68-116 GHz) has been discussed in several memos [1]-[3], and later presented in a proposal by the GBT 3mm Receiver Working Group [4]. It was decided that the first receiver module to be built should be capable of both continuum detection and spectroscopy in the 68-92 GHz band (Module 1). Other frequencies and capabilit...
متن کاملΣ∆ ADC Design Considerations for an UMTS Receiver
This paper gives an insight on how to derive the minimum required specifications both for the anti-aliasing filter (AAF) and the analog-to-digital converter (ADC) in the case of an UMTS receiver. Based on the receiver specifications, we come up with a design plan for both discrete time Σ∆ ADC as well as for a continuous time Σ∆ ADC.
متن کاملCMOS IC Stuck-Open Fault Electrical Effects and Design Considerations
The electrical effects of CMOS IC physical defects that caused stuck-open faults are evaluated, including their voltage levels, quiescent power supply current (IDDQ), transient response, and important testing considerations. The transient responses of the defective node voltage and power supply current to the high impedance state caused by a stuck-open defect were measured to determine if the I...
متن کاملTypical Ka band Satellite Beacon Receiver Design for Propagation Experimentation
This paper presents the design and simulation of a typical Ka band satellite beacon receiver for propagation experimentation. Using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. Satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Institute of Television Engineers of Japan
سال: 1972
ISSN: 1884-9644
DOI: 10.3169/itej1954.26.804