Deformation Behavior of Directionally Solidified Mg-4 wt.% Zn Alloy during Hot Compression Experiment
نویسندگان
چکیده
منابع مشابه
Microstructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
The hot deformation behavior and microstructural evolution of an Al-Zn-Mg-Cu (7150) alloy was studied during hot compression at various temperatures (300 to 450 °C) and strain rates (0.001 to 10 s-1). A decline ratio map of flow stresses was proposed and divided into five deformation domains, in which the flow stress behavior was correlated with different microstructures and dynamic softening m...
متن کاملMicrostructure Evolution and Biodegradation Behavior of Laser Rapid Solidified Mg–Al–Zn Alloy
The too fast degradation of magnesium (Mg) alloys is a major impediment hindering their orthopedic application, despite their superior mechanical properties and favorable biocompatibility. In this study, the degradation resistance of AZ61 (Al 6 wt. %, Zn 1 wt. %, remaining Mg) was enhanced by rapid solidification via selective laser melting (SLM). The results indicated that an increase of the l...
متن کاملThe microstructure , tensile properties , and creep behavior of Mg – Zn alloys containing 0 – 4 . 4 wt . % Zn
This paper describes the microstructure, tensile, and tensile–creep behavior of a series of Mg–Zn alloys ranging from 0 to 4.4 wt.% Zn. The microstructures consisted of equiaxed hexagonal-close-packed grains with fine precipitates preferentially located at grain boundaries. Some of the microstructures contained fine laths within the equiaxed grains. The finest grain sizes were observed for a Zn...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Metallurgy and Metal Physics
سال: 2020
ISSN: 2631-5076
DOI: 10.35840/2631-5076/9244