Damage types of crossed helical gears with wheels from sintered steel
نویسندگان
چکیده
منابع مشابه
Cycles, wheels, and gears in finite planes
The existence of a primitive element of GF (q) with certain properties is used to prove that all cycles that could theoretically be embedded in AG(2, q) and PG(2, q) can, in fact, be embedded there (i.e. these planes are ‘pancyclic’). We also study embeddings of wheel and gear graphs in arbitrary projective planes.
متن کاملImaging membrane protein helical wheels.
Resonance patterns have been observed in 2D solid-state NMR spectra of the transmembrane segment of M2 protein from Influenza A virus in oriented samples reflecting the helical wheel of this alpha-helix. The center of this pattern uniquely defines the helical tilt with respect to the bilayer normal without a need for resonance assignments. The distribution of resonances from amino acid specific...
متن کاملCooling and Lubrication of High-speed Helical Gears
Centrifugal compressor and turbine manufacturers are building machines that operate at increasingly higher speeds to reduce the size and cost of their equipment. Helical gears are commonly used to step down the speed of these machines to match nominal motor and generator speeds. The demand for higher compressor and turbine speeds has resulted in an increase in the maximum pitch line velocities ...
متن کاملDifferent types Failure in gears-A Review
The objective of this paper to present the recent development in the field of gear failure analysis. By the help of this paper we can know about different types of failure detection and analyzing techniques which is used to reduce these failures from gears. The basic reasons of gear failure misalignment of gear, spalling, pitting etc, follow the reason of gear failure. which is identified from ...
متن کاملDamage Behavior of Sintered Fiber Felts
The reduction of aircraft noise is important due to a rising number of flights and the growth of urban centers close to airports. During landing, a significant part of the noise is generated by flow around the airframe. To reduce that noise porous trailing edges are investigated. Ideally, the porous materials should to be structural materials as well. Therefore, the mechanical properties and da...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2011
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos1102205m