Cutting Forces and Chip Morphology in Medium Density Fiberboard Orthogonal Cutting
نویسندگان
چکیده
منابع مشابه
Research on Cutting Performance of Ceramic Cutting Tools in Milling High Density Fiberboard
The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...
متن کاملInvestigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملMedium Density Fiberboard (mdf) Manufacturing
In this study wheat straw was taken from Ankara province. In order to produce dry process MDF, urea formaldehyde resin was used at the ratio of 8 %, 10 % and 12 %, 1 % ammonium chloride was used as hardening agent on the basis of dry fiber weight. On the other hand, 5, 6 and 7 min. pressing times were applied. Alcohol benzene, cold water, hot water and 1 % NaOH solubility of wheat straw were 5....
متن کاملHypersensitivity pneumonitis related to medium-density fiberboard.
Pneumonitis due to hypersensitivity to wood fiber is mainly associated with the fungus that colonizes it. We present the case of a male affected with hypersensitivity pneumonitis in which the agent implicated was medium-density fiberboard, an engineered product whose main component is pine wood fiber. The causal agent was identified by means of a specific bronchial provocation test.
متن کاملMedium Density Fiberboard from Mixed Southern Hardwoods
Medium-density fiberboards of acceptable quality were made from a mixture of barky chips from 14 southern hardwoods. Boards made from fiber refined at three different plate clearances did not vary significantly in bending, internal bond (IB), or linear expansion. But, lack of replications and the fact that the refiner was not loaded to capacity caused these results to be inconclusive. Increasin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: BioResources
سال: 2014
ISSN: 1930-2126
DOI: 10.15376/biores.9.4.5845-5857