Cupronickel B10 and YG6 interface friction characteristics tested on a friction device for metal cutting
نویسندگان
چکیده
منابع مشابه
Effects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملMicroscopic Friction Studies on Metal Surfaces
Atomically flat and clean metal surfaces exhibit a regime of ultra-low friction at low normal loads. Atomic force microscopy, performed in ultra-high vacuum on Cu(100) and Au(111) surfaces, reveals a clear stick-slip modulation in the lateral force but almost zero dissipation. Significant friction is observed only for higher loads (*4– 6 nN above the pull-off force) together with the onset of w...
متن کاملInfluence of particle characteristics on granular friction
[1] We report on laboratory experiments designed to illuminate grain-scale deformation mechanisms within fault gouge. We vary particle size distribution, grain and surface roughness, and gouge layer thickness to better understand how grain sliding, rolling, dilation, and compaction affect the strength and stability of granular fault gouge. The experiments employed the double direct shear testin...
متن کاملMultiscale Friction Modeling for Sheet Metal Forming
The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes when two surfaces are in contact under a normal load. This is caused by flattening due to combined nor...
متن کاملScrubber: An Interface for Friction-induced Sounds
The Scrubber is a general controller for friction-induced sound. Allowing the user to engage in familiar gestures and feeling actual friction, the synthesized sound gains an evocative nature for the performer and a meaningful relationship between gesture and sound for the audience. It can control a variety of sound synthesis algorithms of which we demonstrate examples based on granular synthesi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2019
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814019890226