Criterion for High Temperature Failure and Grain Boundary Chemistry in Superplastic TZP
نویسندگان
چکیده
منابع مشابه
New empirical failure criterion for shale
A new failure criterion was presented to predict the ultimate strength of shale under the triaxial and polyaxial state of stress. A database containing 93 datasets was obtained from the results of the uniaxial, triaxial, polyaxial compressive tests, an indirect tensile test was collected from reliable references, and this test was carried out on the shale samples taken from the southwestern oil...
متن کاملHighly-translucent, strong and aging-resistant 3Y-TZP ceramics for dental restoration by grain boundary segregation.
Latest trends in dental restorative ceramics involve the development of full-contour 3Y-TZP ceramics which can avoid chipping of veneering porcelains. Among the challenges are the low translucency and the hydrothermal stability of 3Y-TZP ceramics. In this work, different trivalent oxides (Al2O3, Sc2O3, Nd2O3 and La2O3) were selected to dope 3Y-TZP ceramics. Results show that dopant segregation ...
متن کاملHigh Temperature Deformation Behavior of Cr-containing Superplastic Iron Aluminide
Superplastic deformation and high temperature load relaxation behavior of coarse-grained iron aluminides with the composition of Fe-28 at.% Al have been investigated. A series of load relaxation and tensile tests were conducted at temperatures ranging from 600 to 850C. The flow curves obtained from load relaxation tests were found to have a sigmoidal shape and to exhibit stress vs. strain rate ...
متن کاملHigh-Temperature Stability and Grain Boundary Complexion Formation in a Nanocrystalline Cu-Zr Alloy
Nanocrystalline Cu-3 at.% Zr powders with 20 nm average grain size were created with mechanical alloying and their thermal stability was studied from 550–950 C. Annealing drove Zr segregation to the grain boundaries, which led to the formation of amorphous intergranular complexions at higher temperatures. Grain growth was retarded significantly, with 1 week of annealing at 950 C, or 98% of the ...
متن کاملProposals for a Failure Criterion Applicable to Discontinuous Rocks
The existing failure criteria to evaluate discontinuous rocks are predominatly based on the relations between principal stresses at failure. None of the criteria has a direct reference to the magnitude of deformation as a major parameter in rock Several reasons are identified indicating that the selection of peak stress as a major parameter, which is obtained through the evaluation of a failure...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals
سال: 2005
ISSN: 0021-4876
DOI: 10.2320/jinstmet.69.835