Crack Detection Method for Drain by Using Directional Smoothing
نویسندگان
چکیده
منابع مشابه
Crack Detection In Functionally Graded Beams Using Conjugate Gradient Method
In this paper the conjugate gradient (CG) method is employed for identifying the parameters of crack in a functionally graded beam from natural frequency measurement. The crack is modeled as a massless rotational spring with sectional flexibility. By using the Euler-Bernoulli beam theory on two separate beams respectively and applying the compatibility requirements of the crack, the characteris...
متن کاملCRACK DETECTION IN CONCRETE BEAM USING OPTIMIZATION METHOD
Structural damage detection is a field that has attracted a great interest in the scientific community in recent years. Most of these studies use dynamic analysis data of the beams as a diagnostic tool for damage. In this paper, a massless rotational spring was used to represent the cracked sections of beams and the natural frequencies and mode shape were obtained. For calculation of rotational...
متن کاملCrack Detection in Operating Rotors using Directional Harmonic Wavelet Transform
In this paper, a new tool for crack detection in operating rotors based on wavelet theory is described. Customarily, two approximate methods of spectral analysis, i.e. ShortTime Fourier transform and Wigner distribution, have been used to analyse the vibration components of cracked rotors during run-up or run-down periods. However, for both methods, high resolution cannot be achieved simultaneo...
متن کاملPavement Crack Detection Using Spectral Clustering Method
Pavement crack detection plays an important role in pavement maintaining and management, nowadays, which could be performed through remote image analysis. Thus, edges of pavement crack should be extracted in advance; in general, traditional edge detection methods don’t consider phase information and the spatial relationship between the adjacent image areas to extract the edges. To overcome the ...
متن کاملPrediction of Crack Initiation Direction for Inclined Crack Under Biaxial Loading by Finite Element Method
This paper presents a simple method based on strain energy density criterion to study the crack initiation angle by finite element method under biaxial loading condition. The crack surface relative displacement method is used to eliminate the calculation of the stress intensity factors which are normally required. The analysis is performed using higher order four node quadrilateral element. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Electronics, Information and Systems
سال: 2007
ISSN: 0385-4221,1348-8155
DOI: 10.1541/ieejeiss.127.241