CO<SUB>2</SUB> Laser Surface Alloying of Fe-Ti Compact
نویسندگان
چکیده
منابع مشابه
Production of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying
In this research, the production of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying was investigated and evaluated. Ferrotitanium (containing 70%Ti), titanium and graphite were used as the raw materials. Initial mixtures were milled in different time durations under the pure nitrogen atmosphere with the pressure of 5atm. The results showed that when N2 pressure is 5 at...
متن کاملTIG Surface Alloying of Ti-6Al-4V with Nitrogen and Chromium for Improved Tribological Properties
Due to special properties such as low density, high strength and high corrosion resistance Ti-6Al-4V alloy has been used extensively in various industries, especially in the aerospace aspects. However the major problem of this alloy is its poor tribological properties under relatively high loads. In the present study, in order to improve the tribological properties of mentioned alloy, chromium ...
متن کاملFe-doped SnO2 obtained by mechanical alloying
In this work, iron-doped SnO2 powders were prepared by two methods: mechanical alloying and mechanochemical alloying with successive thermal treatment. The influence of different milling conditions such as ball to powder weight ratio, milling time, rotation velocity of supporting disc and the type of iron starting reactive and their Fe concentration on the structural and magnetic properties of ...
متن کاملLASER SURFACE PREPARATION FOR ADHESIVE BONDING OF Ti- 6Al-4V
Adhesively bonded structures are potentially lighter in weight than mechanically fastened ones, but existing surface treatments are often considered unreliable. Two main problems in achieving reproducible and durable adhesive bonds are surface contamination and variability in standard surface preparation techniques. In this work three surface pretreatments were compared: laser etching with and ...
متن کاملSynthesis of Fe-Al-Ti Based Intermetallics with the Use of Laser Engineered Net Shaping (LENS)
The Laser Engineered Net Shaping (LENS) technique was combined with direct synthesis to fabricate L21-ordered Fe-Al-Ti based intermetallic alloys. It was found that ternary Fe-Al-Ti alloys can be synthesized using the LENS technique from a feedstock composed of a pre-alloyed Fe-Al powder and elemental Ti powder. The obtained average compositions of the ternary alloys after the laser deposition ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1990
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.54.11_1293