Correlation of manufacturing defects and impact behaviors of kenaf fiber reinforced hybrid fiberglass/Kevlar polyester composite
نویسندگان
چکیده
In this study, the impact properties of kenaf fibre reinforced hybrid fiberglass/Kevlar polymeric composite was investigated. a new fiber arrangement based on bast as reinforcement to and polyester matrix used fabricate composite. Five different types samples with content volume fraction (0, 15, 45, 60 75%) polymer composites were manufactured. 0% has been control sample. The results showed that hybridization improved properties. These further supported through SEM micrograph manufacturing defects Based literature work, occurs in system reduced mechanical material. Therefore, research correlation behaviors successfully done. As conclusion, highest determined during fabrication significantly lowest behavior.
منابع مشابه
Evaluation of Mechanical and Tribological Properties of Glass/Carbon Fiber Reinforced Polymer Hybrid Composite
Polymer matrix composites used in different industrial applications due to their enhanced mechanical properties and lightweight. However, these materials are subjected to friction and wear situations in some industrial and automobile applications. Therefore, there is a need to investigate the wear properties of polymer matrix composite materials. This article emphasizes the dry abrasive wear be...
متن کاملEnergy Absorption Performances of Square Winding Kenaf Fiber Reinforced Composite Tubes
This paper investigates the energy absorption response of winding kenaf fiber composite tubes when subjected to an axial quasi-static crushing test. The square composites were prepared firstly by submerging the kenaf yarn into resin bath before it is warped around the mould for different number of layers and fiber orientations. The parameters measured were peak load, mean load and specific ener...
متن کاملStudying the effect of fiber size and fiber loading on the mechanical properties of hybridized kenaf/PALF-reinforced HDPE composite
Hybridization, especially where only variant natural lignocelluloses are combined, is fast receiving encouraging attention because it offers a range of properties that may be difficult to obtain with a single kind of reinforcement. In this study, tensile, flexural, and impact properties of hybridized kenaf/PALF-reinforced HDPE composite were studied. Sheets from which tensile, flexural, and imp...
متن کاملTensile and Flexural Analysis of a Hybrid Bamboo/Jute Fiber-reinforced Composite with Polyester Matrix as a Sustainable Green Material for Wind Turbine Blades
Recently, there has been a fast growth in research and investigation in the natural fibre composite due to the advantages of these materials, such us low environmental impact, low cost and good mechanical properties compared to synthetic fibre composites. Much effort has gone into increasing the mechanical performance and applications of natural fibes. This paper examines the mechanical propert...
متن کاملMulti-objective Optimization of Hybrid Carbon/Glass Fiber Reinforced Epoxy Composite Automotive Drive Shaft
In design and fabricate drive shafts with high value of fundamental natural frequency that represented high value of critical speed; using composite materials instead of typical metallic materials could provide longer length shafts with lighter weight. In this paper, multi-objective optimization (MOP) of a composite drive shaft is performed considering three conflicting objectives: fundamental ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polimery
سال: 2021
ISSN: ['0032-2725']
DOI: https://doi.org/10.14314/polimery.2021.1.4