Concurrent Dual-Band Receiver Based on Novel Six-Port Correlator for Wireless Applications
نویسندگان
چکیده
منابع مشابه
Dual-band Six Port Receiver Module on Silicon
This article details the design of six-port direct conversion front-end module for dual-band (1.575GHz and 2.680GHz) applications. Proposed planar architecture consists of single-stage (1:2) Wilkinson Power Divider and three numbers of quarter-wave 3-dB branch-line couplers working simultaneously at dual band of frequencies. Present article describes the designing of each building block and fin...
متن کاملReceiver for Dual Band Applications
This dual-band CMOS receiver for GSM and DCS1800 applications incorporates hardware sharing between two paths to reduce the number of off-chip components [1]. The receiver is an extension of the Weaver single-sideband architecture [2]. Utilized in References 3 and 4, the Weaver architecture performs two consecutive quadrature downconversion operations on the signal and the image such that if th...
متن کاملA Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
متن کاملA Novel AoA Positioning Solution for Wireless Ad Hoc Networks Based on Six-Port Technology
Mobile device positioning in ad hoc networks is a crucial issue due to the network properties and hardware limitations of particular devices (nodes). In this paper, a new conception of mobile device based on software defined radio architecture for mobile positioning in ad hoc networks is proposed. Sixport technology is implemented into our software defined radio receiver. Angle of arrival local...
متن کاملDual-Band Evanescent-Mode Substrate Integrated Waveguide Band-pass Filter for WLAN Applications
A new multi-layer substrate integrated waveguide (SIW) structure is developed to design dual-band evanescent-mode band-pass filters (BPFs). Two independent series LC circuits are implemented by incorporating metallic irises in the different layers of the structure. The combination of the metallic irises with capacitive-plates is embedded inside the SIW to independently excite two evane...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2017
ISSN: 2169-3536
DOI: 10.1109/access.2017.2768364