Compared with Angle –ply and Cross-ply Natural Fiber Orientation Pipe under Thermal Load
نویسندگان
چکیده
منابع مشابه
Non-destructive Characterization of Ply Orientation and Ply Type of Carbon Fiber Reinforced Laminated Composites
As the fuel efficiency of vehicles is being increased over the next decade due to both consumer demand and regulations, several automobile manufacturers are incorporating fiber-reinforced composites into their product line due to their high strength to weight ratio. While the fiber-reinforced components are lighter than the traditional aluminum and steel components, the processing and repair of...
متن کاملThermal expansion of unidirectional and cross-ply fibrous monoliths
An investigation of the thermal expansion behavior of ceramic fibrous monoliths (FMs) is presented. The emphasis is on the development and validation of material models applicable to Si3N4/BN FMs in both unidirectional and cross-ply architectures. Approximate analytical models are developed for the coefficient of thermal expansion (CTE) based on the analysis of representative unit cells of the ...
متن کاملInterlaminar fatigue crack growth of cross-ply composites under thermal cycles
The fatigue growth of a fiber reinforced composite laminate was characterized under thermal cycling using a combined experimental and computational investigation. Twenty-four ply composite laminates (1⁄20 12=90 12 ) are fabricated with a pre-existing delamination, and subjected to thermal cycling in an environmental chamber. The large mismatch in the coefficients of thermal expansion is used to...
متن کاملThe Formation and Effect of Outer-Ply Microcracks in Cross-Ply Laminates: A Variational Approach
The microcracking process in laminates which have outer-ply 90◦ plies (e.g. [90m/0n]s) has some important differences from the microcracking process in laminates which lack outer-ply 90◦ plies (e.g. [0n/90m]s). Foremost among the differences is the characteristic damage state. [90m/0n]s laminates form antisymmetric or staggered microcracks while [0n/90m]s laminates form symmetric microcracks. T...
متن کاملBuckling and vibration analysis of angle -ply symmetric laminated composite plates with fully elastic boundaries
The main focus of this paper is on efficiency analysis of two kinds of approximating functions (characteristic orthogonal polynomials and characteristic beam functions) that have been applied in the Rayleigh-Ritz method to determine the non-dimensional buckling and frequency parameters of an angle ply symmetric laminated composite plate with fully elastic boundaries. It has been observed that o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2021
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1783/1/012088