منابع مشابه
Temperature-adaptive voltage tuning for enhanced energy efficiency in ultra-low-voltage circuits
Circuits optimized for minimum energy consumption operate typically in the subthreshold regime with ultra-low power-supply voltages. Speed of a subthreshold logic circuit is enhanced with an increase in the die temperature. The excessive timing slack observed in the clock period of subthreshold logic circuits at elevated temperatures provides opportunities to lower the active-mode energy consum...
متن کاملassessment of the efficiency of s.p.g.c refineries using network dea
data envelopment analysis (dea) is a powerful tool for measuring relative efficiency of organizational units referred to as decision making units (dmus). in most cases dmus have network structures with internal linking activities. traditional dea models, however, consider dmus as black boxes with no regard to their linking activities and therefore do not provide decision makers with the reasons...
The Energy Dependence of the Photoelectric Attenuation Coefficient of Substances
Introduction: The photoelectric attenuation coefficient of substances is known to depend upon the energy E of the photon and the effective atomic number of substances (Zeff) as (Zeffx/Ey). No definitive values about these indices x, y are given in the literature. The index x is said to lie between, 3.0 and 4.0, while for ‘y’ different values have been assigned, between 3.0 and 4.0. Method...
متن کاملFGD gypsum, heat insulation system, heat transfer coefficient, foaming agent, energy efficiency
Thermal insulation gypsum plaster was prepared from flue gas desulphurization (FGD) gypsum. K12 is more recommendable as foaming agent, when the mass fraction of K12 is around 0.1 %, the setting time and compressive strength meet the requirements of gypsum-based construction materials. In the meanwhile, the thermal conductivity is 0.18 W m−1 K−1, which can be used as a thermal insulation materi...
متن کاملA High PSRR Voltage Reference for High Efficiency Power Management Circuit of MEMS Energy Harvesters
A high power supply rejection ratio (PSRR) bandgap voltage reference (BGR) which is used in the signal processing circuit of energy harvesters is presented in this paper. The PSRR of the BGR is improved by adding a pre-regulating circuit and a low pass filter. The pre-regulating circuit mainly improves the BGR PSRR at low frequency and the low pass filter mainly improves the BGR PSRR at high fr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.2988725