منابع مشابه
Regularization of chattering phenomena via bounded variation controls
In control theory, the term chattering is used to refer to fast oscillations of controls, such as an infinite number of switchings over a finite time interval. In this paper we focus on three typical instances of chattering: the Fuller phenomenon, referring to situations where an optimal control features an accumulation of switchings in finite time; the Robbins phenomenon, concerning optimal co...
متن کاملDesign of Moving Sliding Surfaces in A Variable Structure Plant & Chattering Phenomena
This paper deals with the design of a moving sliding surface in a variable structure plant for a second order system. The chattering phenomena is also dealt with during the switching process for an unstable sliding surface condition. The simulation examples considered in this paper shows the effectiveness of the sliding mode control method used for the design of the moving sliding surfaces. A s...
متن کاملModeling of the Process of Coal Grinding
T. Wyleciał, H. Radomiak, D. Urbaniak, Częstochowa University of Technology, Czestochowa, Poland The use of coal in the steel industry, similarly as in the whole national ec onomy, is often preceded by its pre-treatment. Coal is mined in the form of big solids, but, being in such a form, it can’t be combusted, sintered, or gasifi ed. Therefore, it needs t o be appropriately grinding. In the pap...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملAssessment of Working Conditions of Grinding Wheels in the Grinding Process of Hard-To-Cut Materials
Abstract This study here by presents a method for comparative assessment of grinding wheels during the grinding process of hard-to-cut materials. The method in question consists of carrying out a short grinding cut in plunge grinding kinematics using grinding wheels with a customized macro-geometry upon the active surface. The work presents examples of this method’s efficacy when applied to the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1969
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.35.586