CeO2Co3O4CuO anode for direct utilisation of methane or ethanol in solid oxide fuel cells

Pt based anode catalysts for direct ethanol fuel cells

In the present work several Pt-based anode catalysts supported on carbon XC-72R were prepared with a novel method and characterized by means of XRD, TEM and XPS analysis. It was found that all these catalysts are consisted of uniform nanosized particles with sharp distribution and Pt lattice parameter decreases with the addition of Ru or Pd and increases with the addition of Sn or W. Cyclic vol...

Importance of Anode Microstructure in Modeling Solid Oxide Fuel Cells

A one-dimensional button-cell model is developed and applied to explore the influence of anode microstructure on solid oxide fuel cell (SOFC) performance. The model couples porous-media gas transport and elementary electrochemical kinetics within a porous Ni-YSZ cermet anode, a dense YSZ electrolyte membrane and a composite LSM-YSZ cathode. In all cases the fuel is humidified H2 and air is the ...

Direct hydrocarbon solid oxide fuel cells.

Transient studies of perovskite anode catalyst for a direct CH4 Solid Oxide Fuel Cell

Introduction: The direct use of CH4 as the feed to the solid oxide fuel cell (SOFC) will allow elimination of a reformer, simplifying the SOFC system and decreasing the system cost [1]. The overall reaction on the anode catalyst in the direct CH4 SOFC is the electrochemical oxidation of CH4: CH4 + 4O CO2 + 2H2O + 8e. Due to the nature of hydrocarbon reactions at high temperature and the reducin...

Ceramic - Based Anode for Solid - Oxide Fuel Cell Utilizes

490 MRS BULLETIN/JULY 2002 nated by intergranular fracture, while in AJM it was in a manner resembling ductile behavior. Improved surface finishing by AJM resulted in a 15% improvement in flexural strength, compared with both ground and ground-plus-lapped samples. The researchers concluded that a higher compressive residual stress observed on the AJM-processed surface, combined with the smoothe...