Castability tests applied to an aluminium-copper alloy
نویسندگان
چکیده
منابع مشابه
Metallographic Observation to Determine a Low-content Gold Alloy Castability
Low gold-content dental alloys nowadays represent viable alternatives to high nobility alloys. The casting techniques and equipment used for low-gold content alloys are similar to those used for conventional gold alloys. This, coupled with their acceptable properties, good clinical performance and lower cost, has lead to their widespread use. The alloy performance in the dental laboratory is an...
متن کاملSurface characteristics and castability of Zr-14Nb alloy dental castings.
The purpose of this study was to evaluate mechanical properties, surface characteristics and castability of Zr-14Nb dental castings. The mean 0.2% proof and ultimate tensile strengths of Zr-14Nb were approximately 68% and 76% those of Ti-6Al-7Nb, respectively, while they were comparable to Co-29Cr-6Mo. Elongation of Zr-14Nb was the highest of all alloys tested. The hardened reaction layer was f...
متن کاملEffects of Casting Speed and Runner Angle on Macrosegregation of Aluminium-Copper Alloy.
Abstract During the solidification of binary metal alloys, chemical heterogeneities at product scale over a long distance range (1cm-1m) develop and this has detrimental effect on the resulting mechanical properties of cast products. Macrosegregation is of great concern to alloy manufacturers and end users as this problem persist. In this study, the use of process parameters namely casting spee...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملResidual Strength Improvement of an Aluminium Alloy Cracked Panel
This work deals with the application of the micromechanical Gurson-Tvergaard (GT) model to the determination of the residual strength of analuminumflat stiffened panel (2024 T3) with a central through crack, by means of finite element simulations. The load condition is represented by a monotonic traction along the direction orthogonal to the crack plane. The used Finite Element code is WARP 3D,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1993
ISSN: 1155-4339
DOI: 10.1051/jp4:1993737