Built-up edge formation mechanisms in orthogonal cutting of wood-plastic composite

numerical simulation of orthogonal cutting process and determination of built up layer thickness

the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

شبیه‌سازی المان محدود فرایند برش متعامد و تعیین ضخامت لایه چسبنده به ابزار در ناحیه دوم برش

The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...

Cutting Edge: Two Distinct Mechanisms

Study on the microstructure and binding mechanisms of Selective laser sintered wood plastic composite

A new type of wood plastic composite, Eucalyptus/PES(Polyethersulfone) blend, was developed. It was designed to be used in LS (Laser Sintering) with reduced energy usage with cost savings. The preparation of Eucalyptus/PES blend and part sintering were under fixed processing conditions and parameters. Through mechanical testing, it was discovered that the strength of prototypes is low due to th...

Statistical reliability analyses of two wood plastic composite extrusion processes

Estimates of the reliability of wood plastic composites (WPC) are explored for two industrial extrusion lines. The goal of the paper is to use parametric and non-parametric analyses to examine potential differences in the WPC metrics of reliability for the two extrusion lines that may be helpful for use by the practitioner. A parametric analysis of the extrusion lines reveals some similarities ...