Bonding of Tungsten and Graphite Using Spark Plasma Sintering for Divertor Component in LHD
نویسندگان
چکیده
The manufacturing of tungsten (W) - graphite bonded divertor components for the Large Helical Device (LHD) has been investigated. spark plasma sintering method was used to bond W and with titanium (Ti) interlayer. Small specimens were fabricated investigate bonding strength diagnose interface. granular structure formed in grooved area on surface. It suggested that this had affected strength.
منابع مشابه
Chemical Synthesis and Oxide Dispersion Properties of Strengthened Tungsten via Spark Plasma Sintering
Highly uniform oxide dispersion-strengthened materials W-1 wt % Nd₂O₃ and W-1 wt % CeO₂ were successfully fabricated via a novel wet chemical method followed by hydrogen reduction. The powders were consolidated by spark plasma sintering at 1700 °C to suppress grain growth. The samples were characterized by performing field emission scanning electron microscopy and transmission electron microsco...
متن کاملFull densification of Molybdenum powders using Spark Plasma Sintering
Pure molybdenum powder was sintered using Spark Plasma Sintering under various temperatures, and holding times, under a pressure of 77 MPa and a heating rate at 700°C/min. After sintering, a carbide layer was observed at the surface. The carbide layer thickness, the relative density of the sample as well as the microhardness and the grain size of Mo were measured. The carbide thickness depends ...
متن کاملApplication of Spark Plasma Sintering for Manufacturing of Thermoelectric Materials
V-VI thermoelectric compounds like Bi2Te3-based alloys are well known for room temperature applications like Peltier coolers or thermogenerators. Their anisotropic physical properties and mechanical weakness are a problem for the manufacturing. To overcome the mechanical problem Spark Plasma Sintering (SPS) was used. 2 inch Wafers of polycrystalline bismuth telluride based n-type and p-type the...
متن کاملComparison of Creep Behavior in Alumina Based Ceramics Densified by Spark Plasma Sintering and Hot Pressing
Spark plasma sintering (SPS) method, as plasma activated sintering, is a method applicable for rapid sintering of metals and ceramics. Owing to the advantage of rapid heating, the alumina ceramics obtained by SPS have a grain size and density comparable to those of hot pressed ones. The increase of densification rate may be related to some difference in ion transport characteristics. This study...
متن کاملSpark Plasma Synthesis (SPS) Device for Sintering of Nanomaterials
It is known that work pieces with nanocrystalline structure condition have much higher performance than those with an ordinary structure. There are known number of techniques for manufacturing of nanocrystalline materials in powder condition however a question of manufacturing bulk pieces in the same nanocrystalline state mentioned is that compaction and synthesizing of nanocrystalline powders ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Plasma and Fusion Research
سال: 2023
ISSN: ['1880-6821']
DOI: https://doi.org/10.1585/pfr.18.1205003