Boiler Flue Gas Oxygen Content Soft Sensor Based on FSVM
نویسندگان
چکیده
منابع مشابه
Effects of Flue Gas Internal Recirculation on NOx and SOx Emissions in a Co-Firing Boiler
Volumetric combustion has been developed to realize a high substitution ratio of biomass in co-firing boilers, which features an intensive flue gas internal recirculation inside furnace. However, the characteristics of NOx and SOx emissions in large-scale boilers with volumetric combustion were not fully clear. In this paper, an Aspen Plus model of volumetric combustion system was built up base...
متن کاملModeling and Simulation of Complex Fluid Networks in the Flue Gas System of a Boiler
Abstract: Under the conditions of high demand for energy saving and environmental protection, the thermal power unit is required to phase out the traditional extensive operation mode—a method of oxygen-enriched combustion in a furnace, considering safety first. Achieving efficient and economic operation with an optimal proportion of air distribution in these thermal power units is crucial. The ...
متن کاملFlue Gas Analysis Based on Recursive Iteration Algorithm
The key point of flue gas spectra analysis is how to separate and calculate the concentration of different kinds of gas, which is from continuous mixed gas absorption spectrum signal. In this paper, a new iteration of the recursive algorithm is put forward on the basis of Lambert-Beer's law. This algorithm, using the superposition of the absorbance, achieves data nonlinear fitting. It takes the...
متن کاملCouple Stress Effect on Micro/Nanocantilever-based Capacitive Gas Sensor
Micro/nanocantilevers have been employed as sensors in many applications including chemical and biosensing. Due to their high sensitivity and potential for scalability, miniature sensing systems are in wide use and will likely become more prevalent in micro/nano-electromechanical systems (M-NEMSs). This paper is mainly focused on the use of sensing systems that employ micro/nano-size cantilever...
متن کاملGas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber
One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Modeling and Simulation
سال: 2016
ISSN: 2324-8696,2324-870X
DOI: 10.12677/mos.2016.54026